Phone Grip+ montieren: Handyhalter am Lenker oder Vorbau befestigen

Schritt für Schritt

1. 1
   Choose the mounting position: handlebar or stem

   The Phone Grip+ fits either on the handlebar or on the stem. On the handlebar the display is closer to your hand; on the stem the handlebar stays free for your light and bell. Pick the spot where you can see the display well while riding without covering the brake levers.

2. 2
   Fit the rubber strip, add the reducer sleeve if needed

   Place the supplied rubber strip around the clamping point. It protects the handlebar from scratches and gives the clamp grip. If your handlebar or stem is thinner, also slide the reducer sleeve into the clamp so it sits snugly.

3. 3
   Close the handlebar clamp

   Place the two halves of the handlebar clamp around the handlebar or stem, with the mounting arm facing up. Tighten the two clamp screws alternately with the supplied Allen key until the clamp is firm and can no longer twist.

4. 4
   Screw the holder plate onto the arm

   Put the holder plate on the clamp's mounting arm and screw both together with the supplied screw. Align the plate so the display will face you, then tighten the screw with the Allen key.

5. 5
   Stick on the rubber pads

   Stick the rubber pads onto the inside of the four holding claws. They protect your smartphone from scratches and pressure marks and make sure it doesn't slip in the holder.

6. 6
   Insert the smartphone and set the width

   Loosen the knurled screw on the side of the plate, place the smartphone between the four claws and tighten the screw again until all four corners grip. The scale on the plate ranges from 50 to 100 mm – the case can stay on.

   Quick check: Give the phone a shake before your first ride. If anything moves, tighten the knurled screw or the clamp screws.